ENGINE SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.



2. REMOVE FRONT CONSOLE UPPER PANEL GARNISH


B111912
  1. Using a clip remover, detach the claws and remove the garnish.

    HINT:
    Tape the clip remover tip before use.



3. REMOVE CONSOLE UPPER PANEL ASSEMBLY


B110191
  1. Twist the shift lever knob in the direction indicated by the arrow and remove it.



    B111908E01
  1. Using a screwdriver, detach the 9 clips.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the ash receptacle and then disconnect the connector.



4. REMOVE INSTRUMENT PANEL FINISH PANEL END LH


B105636E09
  1. Remove the screw.

  1. Using a screwdriver, detach the 4 clips and 3 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the finish panel end.



5. REMOVE FRONT DOOR SCUFF PLATE LH


B111627E01
  1. Using a moulding remover, detach the 5 claws and remove the scuff plate.



6. REMOVE FRONT DOOR OPENING TRIM COVER LH
  1. Using a moulding remover, detach the 3 claws and remove the trim cover.



7. REMOVE INSTRUMENT SIDE PANEL LH


B105642E01
  1. Using a screwdriver, detach the 2 claws and 4 clips, and remove the side panel.

    HINT:
    Tape the screwdriver tip before use.



8. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


B105644E01
  1. Remove the 2 screws.

  1. Detach the 2 claws.

  1. Remove the under cover and then disconnect the connector.



9. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY


B105646E04
  1. Using a screwdriver, detach the 8 clips and claw.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the hood lock control cable from the safety pad.

  1. Remove the safety pad.



10. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY


11. REMOVE ENGINE SWITCH


B111349E03
  1. Disconnect the switch connector.

  1. Detach the 2 claws and remove the switch.