WASHER NOZZLE > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE WASHER NOZZLE SUB-ASSEMBLY


  1. With the engine running, check that the center stream of washer fluid sprays on the windshield within the hatched areas shown in the illustration.

    Standard:
    Center stream of washer fluid sprays on windshield properly.

    If the result is not as specified, replace the washer nozzle.


    B108103E01

    Specification:
    Area
    		Measurement
    A
    		54.2 mm (2.13 in.)
    B
    		54.2 mm (2.13 in.)
    C
    		144.8 mm (5.70 in.)
    D
    		144.8 mm (5.70 in.)