REAR SPOILER > INSTALLATION

for Preparation Click here

Heating temperature:

Item	Temperature
Vehicle Body	40 to 60°C (104 to 140°F)
Spoiler	20 to 30°C (68 to 86°F)

NOTICE:

Do not heat the body and spoiler excessively.

HINT:

1. When installing the spoiler, heat the vehicle body and spoiler using a heat light.
   
2. A bolt without a torque specification is shown in the standard bolt chart (Click here).
   

1. Clean the vehicle body surface.
   
   

   1. Using a heat light, heat the vehicle body surface.
      

   2. Remove the double-sided tape from the vehicle body.
      

   3. Wipe off any tape adhesive residue with cleaner.
      

2. If reusing the spoiler:
   Clean the spoiler.
   
   

   1. Using a heat light, heat the spoiler.
      

   2. Remove the double-sided tape from the spoiler.
      

   3. Wipe off any tape adhesive residue with cleaner.
      

   4. Apply new double-sided tape to the spoiler.
      

3. Install the spoiler.
   
   

   1. Using a heat light, heat the vehicle body and spoiler.
      

   2. Remove the peeling paper from the face of the spoiler.
      

      HINT:

      After removing the peeling paper, keep the exposed adhesive free from foreign matter.

   
   
   

   3. Install the spoiler with the 4 nuts and clip.
      

1. Install the door cover with the 11 clips.
   

1. Install the assist grip with the 2 screws.
   

2. Attach the 4 claws to install the assist grip cover.