REAR SUSPENSION NO. 1 ARM > INSTALLATION

for Preparation Click here

1. Temporarily install the rear suspension No.1 arm with the 2 bolts and 2 nuts.
   

1. Jack up the axle carrier, with a wooden block placed between the jack and axle carrier, to apply load to the rear suspension so that the rear drive shaft assembly becomes level.
   

1. Fully tighten the 2 bolts.
   

   Torque:

   Bolt A:

   95 N*m{ 970 kgf*cm , 70 ft.*lbf }

   Bolt B:

   100 N*m{ 1,020 kgf*cm , 74 ft.*lbf }

   NOTICE:

   Turn the bolt while holding the nut.

1. Install the rear floor side member cover with the 2 screws.
   

1. Install the differential No.2 support protector with the 2 nuts.
   

Torque:

103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }