REAR SUSPENSION NO. 2 ARM > INSTALLATION

for Preparation Click here

1. Temporarily install the rear suspension No.2 arm with the bolt, nut and washer.
   

2. Temporarily install the rear suspension No.2 arm with the bolt and nut.
   

3. Temporarily install the rear shock absorber with coil spring with the bolt and nut.
   

4. Temporarily install the stabilizer link assembly and the load sensing valve sensor bracket to the rear suspension No.2 arm with the bolt and nut.
   

1. Jack up the axle carrier, with a wooden block placed between the jack and axle carrier, to apply load to the rear suspension so that the rear drive shaft assembly becomes level.
   

1. Fully tighten the bolt on the axle carrier side.
   

   Torque:

   161 N*m{ 1,640 kgf*cm , 119 ft.*lbf }

   NOTICE:

   Turn the bolt while holding the nut.

2. Fully tighten the bolt holding the rear shock absorber with coil spring.
   

   Torque:

   110 N*m{ 1,120 kgf*cm , 81 ft.*lbf }

   NOTICE:

   Turn the bolt while holding the nut.

3. Fully tighten the nut holding the rear stabilizer link assembly.
   

   Torque:

   27 N*m{ 275 kgf*cm , 20 ft.*lbf }

4. Fully tighten the nut on the rear suspension member side.
   

   Torque:

   140 N*m{ 1,430 kgf*cm , 103 ft.*lbf }

1. Install the rear suspension member brace with the 2 bolts.
   

   Torque:

   50 N*m{ 510 kgf*cm , 37 ft.*lbf }

1. Install the differential No.2 support protector with the 2 nuts.
   

Torque:

103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }