REAR SUSPENSION NO. 2 ARM > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. REMOVE DIFFERNTIAL SUPPORT NO.2 PROTECTOR


    G033363

  1. Remove the 2 nuts and the differential No.2 support protector.



3. REMOVE REAR SUSPENSION MEMBER BRACE


    G033264

  1. Remove the 2 bolts and rear suspension member brace.



4. REMOVE REAR SUSPENSION NO. 2 ARM


    C106395E02

  1. Remove the bolt and nut, and disconnect the rear stabilizer link assembly and the load sensing valve sensor bracket.

  1. Remove the bolt and nut, and disconnect the rear shock absorber with coil spring.

    NOTICE:
    Turn the bolt while holding the nut.

  1. Remove the nut and bolt on the axle carrier side, and separate the rear suspension No.2 arm.

    NOTICE:
    Turn the bolt while holding the nut.

  1. Remove the bolt, nut, and washer on the rear suspension member side, and remove the rear suspension No.2 arm.