TIRE PRESSURE MONITOR VALVE > DISPOSAL

for Preparation Click here


HINT:
The tire pressure monitor valve sub-assembly is powered by a lithium battery. When disposing of the tire pressure sensor sub-assembly, remove the battery and dispose of it correctly.



1. DISPOSE OF THE TIRE PRESSURE MONITOR VALVE SUB-ASSEMBLY


    F046448

  1. Use the tip of a screwdriver to pry off the back cover.



    F046449E01

  1. The battery and base board covered with silicone resin are exposed. While taking out the battery, cut off the 2 terminals that connect the battery and the base board.