TIRE PRESSURE MONITOR RECEIVER > REPLACEMENT

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  1. Disconnect the cable from the negative battery terminal.



2. REMOVE ROOF HEADLINING ASSEMBLY

HINT:
Refer to the instructions for removal of the roof headlining assembly (Click here).



3. REMOVE TIRE PRESSURE MONITOR RECEIVER ASSEMBLY

  1. Disconnect the connector.



    C105320E01

  1. Remove the bolt and the tire pressure monitor receiver assembly.



4. INSTALL TIRE PRESSURE MONITOR RECEIVER ASSEMBLY


    C105320E01

  1. Install the tire pressure monitor receiver assembly with the bolt.

    Torque:
    7.5 N*m{ 77 kgf*cm , 66 in.*lbf }

  1. Connect the connector.



5. INSTALL ROOF HEADLINING ASSEMBLY

HINT:
Refer to the instructions for installation of the roof headlining assembly (Click here).



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


7. REGISTRATION OF TRANSMITTER ID
(Click here)


8. INSPECT TIRE PRESSURE WARNING SYSTEM
(Click here)


9. PERFORM INITIALIZATION
Some systems need initialization when disconnecting the cable from the negative battery terminal (Click here).