HOOD SUPPORT ROD > DISPOSAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. DISPOSE OF HOOD SUPPORT ASSEMBLY LH


B065104E03

  1. Remove the support (Click here).

  1. Horizontally fix the support in a vise with the piston-rod pulled out.

  1. Using a metal saw or equivalent, gradually cut any area between A and B to release the gas.

    Specification:
    Area
    		Measurement
    a
    		80 mm (3.15 in.)
    b
    		20 mm (0.80 in.)

    CAUTION:
    As metal debris may be blown outward by the gas, you must:
    1. Wear protective glasses.
    2. Cover the area being cut.

    NOTICE:
    The gas is colorless, odorless and harmless.