EVAPORATOR TEMPERATURE SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT AIR CONDITIONING HARNESS


    E107003E03

  1. Remove the air conditioning harness (A/C evaporator temperature sensor).

  1. Disconnect the connector from the air conditioning harness (A/C evaporator temperature sensor).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    		Condition
    		Specified Condition
    5 - 6
    		-10°C (14°F)
    		7.30 to 9.10 kΩ
    5 - 6
    		-5°C (23°F)
    		5.65 to 6.95 kΩ
    5 - 6
    		0°C (32°F)
    		4.40 to 5.35 kΩ
    5 - 6
    		5°C (41°F)
    		3.40 to 4.15 kΩ
    5 - 6
    		10°C (50°F)
    		2.70 to 3.25 kΩ
    5 - 6
    		15°C (59°F)
    		2.14 to 2.58 kΩ
    5 - 6
    		20°C (68°F)
    		1.71 to 2.05 kΩ
    5 - 6
    		25°C (77°F)
    		1.38 to 1.64 kΩ
    5 - 6
    		30°C (86°F)
    		1.11 to 1.32 kΩ

    NOTICE:
    1. Even slightly touching the sensor may change the resistance value. Be sure to hold the connector of the sensor.
    1. When measuring, the sensor temperature must be the same as the ambient temperature.

    HINT:
    As the temperature increases, the resistance decreases (see the graph).