AIRBAG SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here


HINT:
By accessing the DATA LIST displayed on the intelligent tester, you can perform such functions as reading the values of switches and sensors without removing any parts. Reading the DATA LIST is the first step of troubleshooting and is one method to shorten labor time.


DATA LIST FOR CENTER AIRBAG SENSOR ASSEMBLY

  1. Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG).

  3. Following the display on the tester screen, read the "DATA LIST".

    Item
    		Measure Item/
    Range (Display)
    		Normal Condition
    		Diagnostic Note
    D Seat
    		Driver Seat Position/
    FORWARD: Seat position is forward
    BKWARD: Seat position is backward
    FAIL: Failure detected
    		FORWARD/BKWARD
    		-
    P Detect
    		Passenger Detection/
    NG: Date is not determined
    NONE: No passenger
    DETECT: Exist passenger
    FAIL: Failure detected
    		NONE/DETECT
    		-
    L Bk SW
    		Left side Buckle SW/
    UNSET: The seat belt is not fastened
    SET: The seat belt is fastened
    NG: Data is not determined
    		UNSET/SET
    		-
    R Bk SW
    		Right side Buckle SW/
    UNSET: The seat belt is not fastened
    SET: The seat belt is fastened
    NG: Data is not determined
    		UNSET/SET
    		-
    Disp Typ
    		Display Type Information/
    LR: The display is indicated by LH/RH
    DP: The display is indicated by Driver/Passenger
    		LR
    		-
    #Past Codes
    		Number of Past DTC/
    Min.: 0, Max.: 255
    		0
    		-