ELECTRONICALLY CONTROLLED BRAKE SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


If there are no DTCs output but the problem still occurs, check the circuits for each problem symptom in the order given in the table below and proceed to the relevant troubleshooting page.

NOTICE:
When replacing the skid control ECU, sensor, etc., make sure that turn engine switch is turned off, the stop light switch is off, 2 minutes have elapsed since the driver's door was closed.

HINT:
  1. Inspect the fuse and relay before investigating the suspected areas shown in the table below.
  2. Inspect each malfunctioning circuit in numerical order for the corresponding symptom.
  3. Since the oil passage is blocked off by the master cut solenoid during ECB control, there is no kickback (vibration) to the brake pedal, creating a quiet operating sound even while the ABS is operating.


ELECTRONICALLY CONTROLLED BRAKE SYSTEM: 
Symptom
Suspected area
See page
ABS, BA and/or EBD does not operate
1. Use a chassis dynamometer, etc. to check the ECB operation
-
2. Check the DTC again and make sure that the normal system code is output
 Click here
3. IG power source circuit
 Click here
4. Front speed sensor circuit
 Click here
5. Rear speed sensor circuit
 Click here
6. Check the brake actuator assembly with the intelligent tester (Check brake actuator assembly operation using the active test function) If abnormal, check the hydraulic circuit for leakage
 Click here
7. If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the skid control ECU
 Click here
ABS, BA and/or EBD does not operate efficiently
1. Check the DTC again and make sure that the normal system code is output
 Click here
2. Front speed sensor circuit
 Click here
3. Rear speed sensor circuit
 Click here
4. Check the brake actuator assembly with the intelligent tester (Check brake actuator assembly operation using the active test function) If abnormal, check the hydraulic circuit for leakage
 Click here
5. If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the skid control ECU
 Click here
VSC and/or TR(A)C does not operate
1. Check that traction control has not operated by carrying out diagnosis (Traction control does not operate while the traction OFF switch is ON and the brake control warning light and SLIP indicator light are ON)
-
2. Check the DTC again and make sure that the normal system code is output
 Click here
3. IG power source circuit
 Click here
4. Check the hydraulic circuit for leakage
-
5. Front speed sensor circuit
 Click here
6. Rear speed sensor circuit
 Click here
7. Yaw rate and acceleration sensor circuit
 Click here
8. Steering angle sensor circuit
 Click here
9. If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the skid control ECU
 Click here
Sensor signal check cannot be done
1. TS and CG terminal circuit
 Click here
2. Skid control ECU
 Click here
DTC check cannot be done
1. Check the DTC again and make sure that the normal system code is output
 Click here
2. TC and CG terminal circuit
 Click here
3. If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the skid control ECU
 Click here
ABS warning light abnormal (Remains on)
1. ABS warning light circuit
 Click here
2. Skid control ECU
 Click here
ABS warning light abnormal (Does not come on)
1. ABS warning light circuit
 Click here
2. Skid control ECU
 Click here
Brake control warning light (Multi information display) abnormal (Remains on)
1. Brake control warning light circuit
 Click here
2. Skid control ECU
 Click here
Brake control warning light (Multi information display) abnormal (Does not come on)
1. Brake control warning light circuit
 Click here
2. Skid control ECU
 Click here
BRAKE warning light abnormal (Remains on)
1. Brake fluid level warning light switch circuit
 Click here
2. BRAKE warning light circuit
 Click here
3. Skid control ECU
 Click here
BRAKE warning light abnormal (Does not come on)
1. BRAKE warning light circuit
 Click here
2. Skid control ECU
 Click here
SLIP indicator light abnormal (Remains on)
1. SLIP indicator light circuit
 Click here
2. Skid control ECU
 Click here
SLIP indicator light abnormal (Does not come on)
1. SLIP indicator light circuit
 Click here
2. Skid control ECU
 Click here
Skid control buzzer abnormal
1. Skid control buzzer circuit
 Click here
2. Skid control ECU
 Click here