SEAT MEMORY SWITCH > INSPECTION

for Preparation Click here



1. INSPECT SEAT MEMORY SWITCH LH


B107936E01

  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    		Switch Condition
    		Specified Condition
    2 (M1) - 5 (E)
    		M1 switch pressed
    		Below 1 Ω
    3 (M2) - 5 (E)
    		M2 switch pressed
    		Below 1 Ω
    4 (M3) - 5 (E)
    		M3 switch pressed
    		Below 1 Ω
    1 (MRY) - 5 (E)
    		SET switch pressed
    		Below 1 Ω

    If the result is not as specified, replace the switch.



2. INSPECT SEAT MEMORY SWITCH RH


B107935E01

  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    		Switch Condition
    		Specified Condition
    2 (1) - 5 (E)
    		M1 switch pressed
    		Below 1 Ω
    3 (2) - 5 (E)
    		M2 switch pressed
    		Below 1 Ω
    4 (3) - 5 (E)
    		M3 switch pressed
    		Below 1 Ω
    1 (MMRY) - 5 (E)
    		SET switch pressed
    		Below 1 Ω

    If the result is not as specified, replace the switch.