TIRE PRESSURE WARNING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


The intelligent tester can be used at steps 3, 7 and 9.


1.Vehicle Brought to Workshop

    NEXT


    2.Customer Problem Analysis

      NEXT


      3.DTC Check and Clear


        		.
        DTC is output: Go to step 4

        		.
        DTC is not output: Go to step 5

        4.DTC Chart


          		.
          Go to step 7

          5.Problem Symptom Confirmation


            		.
            Symptom does not occur: Symptom simulation

            		.
            Symptom occurs: Go to step 6

            6.Problem Symptoms Table


              		.
              Go to step 8

              7.Circuit Inspection

                NEXT


                8.Repair

                  NEXT


                  9.Confirmation Test

                    NEXT

                    End