TIRE PRESSURE WARNING SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

  1. Connect the intelligent tester to DLC3.

  2. Turn the engine switch on (IG).

  3. Following the display on the intelligent tester, read the "DATA LIST".


Item
Measurement item/
Range (Display)
Normal Condition
Diagnostic Note
Mode
Tire pressure warning system
mode/NORMAL or REG 2nd or
REG M or TEST
NORMAL: Normal mode
TEST: Test mode
-
Main
Number of main tire ID to be registered/
0 or 1 or 2 or 3 or 4
0 to 4 should be displayed
-
2nd
Number of 2nd tire ID to be registered/
0 or 1 or 2 or 3 or 4
0 to 4 should be displayed
-
Slct SW
Select Switch Status
No pressing: MAIN
Pressing: 2nd
-
Ini SW
Initialization switch/ON, OFF
ON: Switch on
OFF: Switch off
-
Vhcl Spd
Vehicle speed reading/
min.: 0 km/h (0 mph),
max.: 255 km/h (158 mph)
Actual vehicle speed
Speed indicated on the combination meter
Trans Stat
ID code transmission place/
MAIN or 2nd
MAIN or 2nd
-
ID1 Cod
Registered ID1 code/min.: 0,
max.: FFFFFFF
The ID No. registered in the transmitter
ID1 is displayed
-
ID2 Cod
Registered ID2 code/min.: 0,
max.: FFFFFFF
The ID No. registered in the transmitter
ID2 is displayed
-
ID3 Cod
Registered ID3 code/min.: 0,
max.: FFFFFFF
The ID No. registered in the transmitter
ID3 is displayed
-
ID4 Cod
Registered ID4 code/min.: 0,
max.: FFFFFFF
The ID No. registered in the transmitter
ID4 is displayed
-
Trans Stat
ID code transmission status/
FINISH or NOW
FINISH or NOW
-
Press1
ID1 tire inflation pressure/
min.: 0 kPa (0 kgf*cm2, 0 psi),
max.: 637.5 kPa (6.48 kgf*cm2,92.2 psi)
Actual tire inflation pressure
-
Press2
ID2 tire inflation pressure/
min.: 0 kPa (0 kgf*cm2, 0 psi),
max.: 637.5 kPa (6.48 kgf*cm2,92.2 psi)
Actual tire inflation pressure
-
Press3
ID3 tire inflation pressure/
min.: 0 kPa (0 kgf*cm2, 0 psi),
max.: 637.5 kPa (6.48 kgf*cm2,92.2 psi)
Actual tire inflation pressure
-
Press4
ID4 tire inflation pressure/
min.: 0 kPa (0 kgf*cm2, 0 psi),
max.: 637.5 kPa (6.48 kgf*cm2,92.2 psi)
Actual tire inflation pressure
-
Temp1
ID1 temperature in tire/
min.: -40°C (-40°F),
max.: 215°C (419°F)
Actual tire temperature
-
Temp2
ID2 temperature in tire/
min.: -40°C (-40°F),
max.: 215°C (419°F)
Actual tire temperature
-
Temp3
ID2 temperature in tire/
min.: -40°C (-40°F),
max.: 215°C (419°F)
Actual tire temperature
-
Temp4
ID2 temperature in tire/
min.: -40°C (-40°F),
max.: 215°C (419°F)
Actual tire temperature
-
Volt1
ID1 battery voltage/
OVER or LESS
OVER
-
Volt2
ID2 battery voltage/
OVER or LESS
OVER
-
Volt3
ID3 battery voltage/
OVER or LESS
OVER
-
Volt4
ID4 battery voltage/
OVER or LESS
OVER
-
Slct Info
Select switch setting information/
WITH or WITHOUT
WITH or WITHOUT
-
Ini Info
Initialization switch setting information/
WITH or WITHOUT
WITH or WITHOUT
-
Ini Thre1
ID1 initial threshold of low-pressure/
min.: 0 kPa (0 kgf*cm2, 0 psi),
max.: 637.5 kpa (6.48 kgf*cm2, 92.2 psi)
Tire pressure after initialization
-
Ini THre2
ID2 initial threshold of low-pressure/
min.: 0 kpa (0 kgf*cm2, 0 psi),
max.: 637.5 kpa (6.48 kgf*cm2, 92.2 psi)
Tire pressure after initialization
-
Ini Thre3
ID3 initial threshold of low-pressure/
min.: 0 kpa (0 kgf*cm2, 0 psi),
max.: 637.5 kpa (6.48 kgf*cm2, 92.2 psi)
Tire pressure after initialization
-
Ini Thre4
ID4 initial threshold of low-pressure/
min.: 0 kpa (0 kgf*cm2, 0 psi),
max.: 637.5 kpa (6.48 kgf*cm2, 92.2 psi)
Tire pressure after initialization
-
# Codes
Number of DTC recorded/
min.: 0, max.: 255
Min.: 0, Max.: -
-