HEADLIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE COOL AIR INTAKE DUCT SEAL


B106147

  1. Using a clip remover, remove the 7 clips and duct seal.



3. REMOVE FRONT BUMPER COVER

  1. Using a clip remover, remove the 2 clips.

    HINT:
    Put protective tape under the front fender.



    B109982

  1. Remove the 6 screws and 5 bolts.



    B106150E01

  1. Pull the bumper cover to detach the 3 claws on the LH side.

  1. Pull the bumper cover to detach the 3 claws on the RH side and remove the bumper cover.

  1. w/ Clearance sonar system:
    Disconnect the ultrasonic sensor connector.



4. REMOVE ENGINE ROOM SIDE COVER


A105934E01

  1. Remove the 3 clips and side cover.



5. REMOVE HEADLIGHT ASSEMBLY


B109718

  1. Disconnect the connector as shown in the illustration.



    B109717E01

  1. Remove the 3 bolts.

  1. w/ Headlight cleaner:
    Disconnect the headlight cleaner hose.

  1. Detach the claw and remove the headlight.



6. REMOVE FRONT BUMPER SIDE SUPPORT


B109724

  1. Remove the 3 screws and side support.



7. REMOVE NO. 1 HEADLIGHT BACK COVER


B109733

  1. Turn the back cover in the direction indicated by the arrow and remove it.



8. REMOVE HIGH-INTENSITY DISCHARGE HEADLIGHT BULB


    B109734

  1. Turn the bulb in the direction indicated by the arrow and remove the bulb socket.



    B109730E01

  1. Release the set spring lock as shown in the illustration and remove the bulb.



9. REMOVE NO. 2 HEADLIGHT BULB


B109735

  1. Turn the bulb in the direction indicated by the arrow and remove it.



10. REMOVE FRONT TURN SIGNAL LIGHT BULB


B109738

  1. Turn the socket and bulb in the direction indicated by the arrow and remove them as a unit.



11. REMOVE FRONT TURN SIGNAL LIGHT SOCKET

  1. Remove the bulb from the light socket.



12. REMOVE CLEARANCE LIGHT BULB


B109736

  1. Turn the socket and bulb in the direction indicated by the arrow and remove them as a unit.



13. REMOVE CLEARANCE LIGHT BULB SOCKET

  1. Remove the bulb from the socket.



14. REMOVE FRONT SIDE MARKER LIGHT BULB


B109737

  1. Turn the socket and bulb in the direction indicated by the arrow and remove them as a unit.



15. REMOVE FRONT SIDE MARKER LIGHT BULB SOCKET

  1. Remove the bulb from the socket.



16. REMOVE LIGHT CONTROL ECU


B109725

  1. Remove the 4 screws and ECU cover.

  1. Remove the headlight gasket.



    E109372E01

  1. Remove the 2 screws.

  1. Disconnect the connector and remove the ECU.