LICENSE PLATE LIGHT ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. INSTALL BACK DOOR GARNISH RETAINER SUB-ASSEMBLY


E110959E01

  1. Install the 2 clips and retainer to the luggage compartment door.

  1. Install the 2 screws.



2. INSTALL LICENSE PLATE LIGHT ASSEMBLY


B110162E03

  1. Install the license plate light and screw to the luggage compartment door..



    B110161

  1. Connect the connector.



3. INSTALL LUGGAGE COMPARTMENT DOOR GARNISH SUB-ASSEMBLY OUTSIDE


    B111353E06

  1. Attach the 7 clips to install the garnish.



    B109987

  1. Install the garnish with the 3 nuts.



4. INSTALL LUGGAGE COMPARTMENT DOOR COVER


    B110497

  1. Install the door cover with the 11 clips.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


6. PERFORM INITIALIZATION

  1. Perform initialization (Click here ).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.