FOG LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE COOL AIR INTAKE DUCT SEAL


B106147

  1. Using a clip remover, remove the 7 clips and duct seal.



3. REMOVE ENGINE UNDER COVER


B107493

  1. Using a clip remover, remove the 3 clips.

  1. Remove the 10 screws and under cover.



4. REMOVE FRONT BUMPER COVER

  1. Using a clip remover, remove the 2 clips.

    HINT:
    Put protective tape under the front fender.



    B109982

  1. Remove the 6 screws and 5 bolts.



    B106150E01

  1. Pull the bumper cover to detach the 3 claws on the LH side.

  1. Pull the bumper cover to detach the 3 claws on the RH side and remove the bumper cover.

  1. w/ Clearance sonar system:
    Disconnect the ultrasonic sensor connector.



5. REMOVE FOG LIGHT ASSEMBLY


B109932E01

  1. Remove the bolt.

  1. Detach the 2 claws and remove the fog light.



6. REMOVE FOG LIGHT BULB


B109933

  1. Turn the fog light bulb in the direction indicated by the arrow and remove it.