VVT SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here


NOTICE:
In this section, the terms "cold" and "hot" refer to the temperature of the coils. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).



1. INSPECT VVT SENSOR (for Bank 1)


A106640E01

  1. Disconnect the VVT sensor connector.

  1. Measure the resistance of the sensor.

    Standard resistance :
    Condition
    		Specified Condition
    Cold
    		835 to 1,400 Ω
    Hot
    		1,060 to 1,645 Ω

    If the resistance is not as specified, replace the sensor.

  1. Connect the VVT sensor connector.



2. INSPECT VVT SENSOR (for Bank 2)


    A106641E01

  1. Disconnect the VVT sensor connector.

  1. Measure the resistance of the sensor.

    Standard resistance :
    Condition
    		Specified Condition
    Cold
    		835 to 1,400 Ω
    Hot
    		1,060 to 1,645 Ω

    If the resistance is not as specified, replace the sensor.

  1. Connect the VVT sensor connector.