INNER REAR VIEW MIRROR > INSPECTION

for Preparation Click here



1. CHECK INNER REAR VIEW MIRROR ASSEMBLY


    E108528E01

  1. Check operation of the electrochromic inner mirror.

    1. Connect the battery positive (+) lead to terminal 2 and the negative (-) lead to terminal 5.

    2. Attach black colored tape to the forward sensor to prevent it from sensing.

    3. Shine an electric light on the mirror. Check that the mirror surface changes from bright to dark.

      HINT:
      When the environment is very bright, the anti-glare operation may occur immediately after the tape is applied.

      1. If the result is not as specified, replace the mirror assembly.



2. CHECK OUTER REAR VIEW MIRROR ASSEMBLY LH


    E108539E01

  1. Disconnect the mirror connector.

  1. Apply dry cell battery voltage (1.2 V) to the mirror and check operation of the mirror face.

    OK:
    Condition
    		Specified Condition
    Battery positive (+) → 7 (EC+)
    Battery negative (-) → 15 (EC-)
    		Mirror face darkens

    1. If the result is not as specified, replace the mirror assembly.



3. CHECK OUTER REAR VIEW MIRROR ASSEMBLY RH


    E108540E01

  1. Disconnect the mirror connector.

  1. Apply dry cell battery voltage (1.2 V) to the mirror and check operation of the mirror face.

    OK:
    Condition
    		Specified Condition
    Battery positive (+) → 7 (EC+)
    Battery negative (-) → 15 (EC-)
    		Mirror face darkens

    1. If the result is not as specified, replace the mirror assembly.