ENTRY AND START SYSTEM > Entry Lock Function does not Operate on Rear Door LH

for Preparation Click here


DESCRIPTION

When the touch sensor inside the outside door handle rear LH is touched, the multiplex network door ECU rear LH (rear door ECU LH) sends a request signal to the door electrical key oscillator rear LH. The key receives this request and transmits its ID code. Upon receiving the ID code, the certification ECU determines that the key is outside the vehicle and sends a lock signal to the rear door LH lock through the cowl side junction block RH (multiplex network body ECU).

INSPECTION PROCEDURE

1.CHECK MANUAL DOOR LOCK OPERATION

  1. Check that the manual door lock function operates normally.

    OK:
    Manual door lock function operates normally.



NG
GO TO POWER DOOR LOCK CONTROL SYSTEM
OK


2.READ DATA LIST (DOOR COURTESY LIGHT SWITCH)

  1. Check the Data List for proper functioning of the rear LH side door courtesy light switch.

    Multiplex network door ECU rear LH: 
    Item
    		Measurement Item / Range (Display)
    		Normal Condition
    		Diagnostic Note
    Courtesy SW
    		Courtesy light switch / ON or OFF
    		ON: Courtesy light switch is pushed
    OFF: Courtesy light switch is not pushed
    		-

    OK:
    ON (courtesy light switch is pushed) appears on the screen.



NG
GO TO LIGHTING SYSTEM
OK


3.READ DATA LIST (LOCK POSITION SWITCH)

  1. Check the Data List for proper functioning of the door lock position switch.

    Multiplex network door ECU rear LH: 
    Item
    		Measurement Item / Range (Display)
    		Normal Condition
    		Diagnostic Note
    Lock Pos SW
    		Door unlock detection switch signal / ON or OFF
    		ON: Door is unlocked
    OFF: Door is locked
    		-

    OK:
    ON (door is unlocked) appears on the screen.



NG
GO TO POWER DOOR LOCK CONTROL SYSTEM
OK


4.READ DATA LIST (LOCK SWITCH)

  1. Check the Data List for proper functioning of the door lock switch.

    Certification ECU (LHD): 
    Item
    		Measurement Item / Range (Display)
    		Normal Condition
    		Diagnostic Note
    DR Trigger SW
    		Driver side rear door lock switch / ON or OFF
    		ON: Lock switch is pushed
    OFF: Lock switch is not pushed
    		-

    Certification ECU (RHD): 
    Item
    		Measurement Item / Range (Display)
    		Normal Condition
    		Diagnostic Note
    PR Trigger SW
    		Passenger side rear door lock switch / ON or OFF
    		ON: Lock switch is pushed
    OFF: Lock switch is not pushed
    		-

    OK:
    ON (lock switch is pushed) appears on the screen.



NG
REPLACE REAR DOOR OUTSIDE HANDLE ASSEMBLY LH
OK


5.CHECK OPERATION OF MULTIPLEX NETWORK DOOR ECU REAR LH

  1. After replacing the multiplex network door ECU rear LH with a normal one, check that the entry lock function operates normally.

    OK:
    Entry lock function operates normally.



NG
REPLACE CERTIFICATION ECU ASSEMBLY
OK

END (MULTIPLEX NETWORK DOOR ECU REAR LH IS DEFECTIVE)