HEIGHT CONTROL SENSOR > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  1. The procedures listed below are for the LH side.



1. INSTALL HEIGHT CONTROL SENSOR SUB-ASSEMBLY REAR


    C110306

  1. Install the height control sensor with the 2 bolts.

    Torque:
    13.5 N*m{ 138 kgf*cm , 10 ft.*lbf }



    C110305E01

  1. Align matchmarks on the height control sensor and bracket.

  1. Install the nut.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Connect the connector.

  1. Install the rear tire.



2. INSTALL HEIGHT CONTROL SENSOR SUB-ASSEMBLY FRONT


    C101251

  1. Install the height control sensor with the 2 bolts.

    Torque:
    13.5 N*m{ 138 kgf*cm , 10 ft.*lbf }



    C101252

  1. 4WD:
    Install the height control sensor link with the bolt to the lower arm.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



    C101253

  1. 2WD:
    Install the height control sensor link with the nut to the lower arm.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Install the front tire.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. PERFORM INITIALIZATION

  1. Perform initialization (Click here ).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



5. ADJUST HEADLIGHT AIMING


    E109374E01

  1. Adjust the aim vertically:
    Adjust the headlight aim into the specified range by turning aiming screw A with a screwdriver.

    NOTICE:
    The final turn of the aiming screw should be made in the clockwise direction. If the screw is tightened excessively, loosen and then retighten it so that the final turn of the screw is in the clockwise direction.

    HINT:
    1. Perform the low-beam aim adjustment.
    2. The headlight aim moves up when turning the aiming screw clockwise, and moves down when turning the aiming screw counterclockwise.



    E109373E02

  1. Adjust the aim horizontally:
    Adjust the headlight aim into the specified range by turning aiming screw B with a screwdriver.

    NOTICE:
    The final turn of the aiming screw should be made in the clockwise direction. If the screw is tightened excessively, loosen and then retighten it, so that the final turn of the screw is in the clockwise direction.

    HINT:
    1. Perform the low-beam aim adjustment.