HEIGHT CONTROL SENSOR > REMOVAL

for Preparation Click here


  1. The procedures listed below are for the LH side.

HINT:
  1. Use the same procedures for the RH side and LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE HEIGHT CONTROL SENSOR SUB-ASSEMBLY FRONT

  1. Remove the front tire.

  1. Disconnect the connector.



    C101253

  1. 2WD:
    Remove the nut and sensor link from the lower arm.



    C101252

  1. 4WD:
    Remove the bolt and sensor link from the lower arm.



    C101251

  1. Remove the 2 bolts and sensor.



3. REMOVE HEIGHT CONTROL SENSOR SUB-ASSEMBLY REAR

  1. Remove the rear tire.

  1. Disconnect the connector.



    C110305E02

  1. Put matchmarks on the sensor link and bracket.



    C110306

  1. Remove the 2 bolts and sensor.