DTC    B1289    Passenger Seat ECU Communication Stop

for Preparation Click here


SYSTEM DESCRIPTION

This DTC is detected when communication between the position control ECU and switch (passenger seat ECU) and network gateway ECU stops for more than 10 seconds.

DTC No.
DTC Detection Condition
Trouble Area
B1289
Position control ECU communication stops
  1. Position control ECU and switch assembly (passenger seat ECU)
  2. Wire harness

WIRING DIAGRAM


B111309E01


B111310E01


INSPECTION PROCEDURE

1.CHECK OPERATION

  1. Check that the manual switch of the front power seat can move the passenger side seat normally.

    OK:
    Manual switch of front power seat can move passenger side seat normally.



NG
Go to step 2
OK

REPAIR OR REPLACE HARNESS AND CONNECTOR 

2.CHECK WIRE HARNESS (POSITION CONTROL ECU AND SWITCH ASSEMBLY - BATTERY AND BODY GROUND)

B111312E01

  1. Disconnect the c7*1, d7*2 and c6*1, d8*2 ECU connectors.

  1. Measure the resistance and voltage of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    		Specified Condition
    c6-1 (GND)*1 - Body ground
    		Below 1 Ω
    d8-1 (GND)*2 - Body ground
    		Below 1 Ω

    Standard voltage:
    Tester Connection
    		Specified Condition
    c7-8 (SYSB)*1 - Body ground
    		10 to 14 V
    d7-8 (SYSB)*2 - Body ground
    		10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK RESISTANCE OF COMMUNICATION LINE

E109416E02

  1. Disconnect the c7*1, d7*2 and N4*1, O3*2 ECU connectors.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    		Specified Condition
    c7-1 (MPX1)*1 - N4-8 (MPX1)*1
    		Below 1 Ω
    d7-1 (MPX1)*2 - O3-9 (MPX2)*2
    		Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE POSITION CONTROL ECU AND SWITCH ASSEMBLY