COOLING FAN RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK COOLING FAN RELAY (Marking: MAIN FAN)


B087894E01

  1. Remove the relay from the engine room No. 1 relay block.

  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    		Specified Condition
    3 - 5
    		10 MΩ or higher
    3 - 5
    		Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the cooling fan relay.

  1. Install the relay to the engine room No. 1 relay block.