LUGGAGE COMPARTMENT DOOR OPENER AND CLOSER SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

HINT:
Using the intelligent tester's Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG).

  3. Read the Data List on the tester's screen.

    Multiplex network body ECU: 
    Item
    		Measurement Display (Range)
    		Normal Condition
    		Diagnostic Note
    Lid Open SW
    		Luggage door opener switch / ON or OFF
    		ON: Luggage door opener switch is pushed
    OFF: Luggage door opener switch is not pushed
    		-
    Trunk Main SW
    		Luggage door opening switch / ON or OFF
    		ON: Luggage compartment door can be opened by using luggage opener door system
    OFF: Luggage compartment door cannot be opened by using luggage opener door system
    		-

    Cowl side junction block ECU LH: 
    Item
    		Measurement Display (Range)
    		Normal Condition
    		Diagnostic Note
    Luggage Door Lock / Unlock Switch
    		Luggage compartment door key unlock switch / ON or OFF
    		ON: Door is unlocked
    OFF: Door is locked
    		-
    Luggage Push Switch
    		Power luggage door open switch signal / ON or OFF
    		ON: Power luggage door open switch is pushed
    OFF: Power luggage door open switch is not pushed
    		-
    Open Position Switch
    		Luggage door open position switch signal / ON or OFF
    		ON: Door is closed
    OFF: Door is open
    		-
    Close Position Switch
    		Luggage door close position switch signal / ON or OFF
    		ON: Door is open
    OFF: Door is closed
    		-
    Luggage Courtesy Switch
    		Luggage door courtesy switch signal / ON or OFF
    		ON: Door is open
    OFF: Door is closed
    		-


PERFORM ACTIVE TEST

HINT:
Performing the intelligent tester's Active Test allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the Active Test early in troubleshooting is one way to save time. The Data List can be displayed during the Active Test.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG).

  3. Perform the Active Test according to the display on the tester.

    Cowl side junction block ECU LH: 
    Item
    		Test Details
    		Diagnostic Note
    Trunk Lid Open
    		Operate luggage compartment door closer motor
    		-
    Luggage Light Control
    		Operate luggage courtesy switch
    		-