LUGGAGE COMPARTMENT DOOR OPENER AND CLOSER SYSTEM > Luggage Compartment Door Opener Switch Circuit

for Preparation Click here


DESCRIPTION

This circuit detects the state of the luggage door opening switch.

WIRING DIAGRAM


B107448E02


INSPECTION PROCEDURE

1.INSPECT LUGGAGE DOOR OPENING SWITCH ASSEMBLY
B107430E01

  1. Remove the luggage door opening switch.

  1. Measure the resistance of the switch connector.

    Standard resistance:
    Tester Connection
    		Condition
    		Specified Condition
    1 - 2
    		Pushed
    		Below 1 Ω
    1 - 2
    		Not pushed
    		10 kΩ or higher



NG
REPLACE LUGGAGE DOOR OPENING SWITCH ASSEMBLY
OK


2.CHECK WIRE HARNESS (LUGGAGE DOOR OPENING SWITCH ASSEMBLY - MULTIPLEX NETWORK BODY ECU AND BODY GROUND)
B107431E02

  1. Disconnect the L60 switch connector.

  1. Disconnect the L68 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    		Specified Condition
    L60-2 - L68-2 (TSW)
    		Below 1 Ω
    L60-1 - Body ground
    		Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.READ VALUE OF INTELLIGENT TESTER (LUGGAGE COMPARTMENT DOOR OPENER SWITCH)

  1. Check the Data List for proper functioning of the luggage door opener switch.

    Multiplex network body ECU:

    Item
    		Measurement Item / Display (Range)
    		Normal Condition
    		Diagnostic Note
    Lid Open SW
    		Luggage door opener switch / ON or OFF
    		ON: Luggage door opener switch is pushed
    OFF: Luggage door opener switch is not pushed
    		-

    OK:
    "ON" (luggage door opener switch is pushed) appears on the screen.



NG
REPLACE INTEGRATION CONTROL & PANEL ASSEMBLY
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN ON PROBLEM SYMPTOMS TABLE