ROOM TEMPERATURE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL ROOM TEMPERATURE SENSOR


    E108956E01

  1. Install the sensor with the claw.

  1. Connect the connector and attach the air hose.



2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


B108095E01

  1. Connect the connectors.

  1. Attach the 2 claws to install the under cover.

  1. Install the 2 screws.



3. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY


    C106895

  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Install the driver side knee airbag assembly with the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



4. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY


B105646E05

  1. Install the hood lock control cable to the safety pad.

  1. Attach the 8 clips and claw to install the safety pad.



5. INSTALL INSTRUMENT SIDE PANEL LH


B105642E03

  1. Attach the 2 claws and 4 clips to install the side panel.



6. INSTALL FRONT DOOR OPENING TRIM COVER LH

  1. Attach the 3 claws to install the trim cover.

  1. Pull out the folded lip of the weatherstrip.



7. INSTALL FRONT DOOR SCUFF PLATE LH


B111648E02

  1. Attach the 5 claws to install the scuff plate.

  1. Pull out the folded lip of the weatherstrip.



8. INSTALL INSTRUMENT PANEL FINISH PANEL END LH


B105636E10

  1. Attach the 4 clips and 3 claws to install the finish panel end.

  1. Install the screw.



9. INSTALL CONSOLE UPPER PANEL ASSEMBLY


B111908E02

  1. Connect the connector.

  1. Attach the 9 clips to install the ash receptacle.



    B110192

  1. Install the shift lever knob and twist it in the direction indicated by the arrow.



10. INSTALL FRONT CONSOLE UPPER PANEL GARNISH

  1. Attach the claws to install the garnish.



11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


12. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.