LUGGAGE COMPARTMENT DOOR CLOSER ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT LUGGAGE COMPARTMENT DOOR CLOSER ASSEMBLY


B107434E02

  1. Apply battery voltage to the closer motor and check operation of the motor.

    OK:
    Measurement Condition
    		Specified Condition
    Battery positive (+) → Terminal 2 Battery negative (-) → Terminal 6
    		Clockwise
    Battery positive (+) → Terminal 6 Battery negative (-) → Terminal 2
    		Counterclockwise (jam protection function operating)

    1. If the result is not as specified, replace the closer.



    B107439E02

  1. Measure the resistance of the courtesy switch.

    Standard resistance:
    Tester Connection
    		Switch Position
    		Specified Condition
    3 - 4
    		Not pushed (ON)
    		Below 1 Ω
    3 - 4
    		Pushed (OFF)
    		10 kΩ or higher

    1. If the result is not as specified, replace the closer.



  1. Measure the resistance of the open/close position detection switch.


    B107440E04

    Standard resistance (Open switch):
    Tester Connection
    		Closer Position
    		Specified Condition
    1 - 3
    		A, B, E and F
    		Below 1 Ω
    1 - 3
    		C and D
    		10 kΩ or higher

    Standard resistance (Closer switch):
    Tester Connection
    		Closer Position
    		Specified Condition
    1 - 5
    		B and D
    		Below 1 Ω
    1 - 5
    		A, C, E and F
    		10 kΩ or higher

    1. If the result is not as specified, replace the closer.