FRONT POWER SEAT CONTROL SYSTEM (w/ Seat Position Memory System) > Wireless Transmitter Memory Function does not Operate

for Preparation Click here


DESCRIPTION

With the engine switch off and the driver side door closed, press the M1, M2 or M3 switch and the transmitter's LOCK or UNLOCK switch. The multiplex network body ECU will receive a key recognition code signal through wireless radio waves, and send the key recognition code signal to the position control ECU & switch assembly via the BEAN line. The position control ECU & switch assembly then organizes the key recognition code received from the memory switch and sounds the buzzer (answer back) when the code is registered.

INSPECTION PROCEDURE

1.CHECK WIRELESS DOOR LOCK OPERATION (WIRELESS DOOR LOCK / UNLOCK OPERATION)

  1. Using the standard operation procedure, check that the wireless door lock / unlock operates normally.

    OK:
    Wireless door lock / unlock operates normally.

    HINT:
    The standard operating procedure is as follows:
    Hold the transmitter approximately 1 m (3.28 ft) from the driver door outside handle. Press and hold the transmitter's LOCK or UNLOCK switch for 1 second.



NG
GO TO WIRELESS DOOR LOCK CONTROL SYSTEM
OK


2.CHECK SEAT MEMORY SWITCH FUNCTION (SEAT POSITION MEMORY FUNCTION)

  1. Perform a memory operation properly. Check that the buzzer sounds to indicate the completion of the memory operation.

    NOTICE:
    1. The seat position will not be recorded if the SET switch and 2 or more of the memory switches (for example, M1 and M2) are pressed simultaneously.
    2. If a memorizing operation has failed, release all switches. The seat memory function does not operate unless the switches are released.

    OK:
    Seat memory switch function operates normally.



NG
GO TO PROBLEM SYMPTOMS TABLE
OK


3.CHECK MEMORY CALL FUNCTION (REGISTER RECOGNITION CODE)

  1. While pressing the M1, M2 or M3 switch, press the transmitter's LOCK or UNLOCK switch. Check that the buzzer sounds normally.

    OK:
    Buzzer sounds normally.



NG
REPLACE POSITION CONTROL ECU & SWITCH ASSEMBLY (DRIVER SIDE)
OK

END