AUDIO AND VISUAL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here




1.VEHICLE BROUGHT IN WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK

      NEXT


      3.INSPECT DIAGNOSTIC TROUBLE CODES

      1. If the audio system is equipped with a multi-display, check DTCs in the LEXUS NAVIGATION SYSTEM section.

      2. If the system cannot enter the diagnosis mode, inspect each AVC-LAN communication signal and repair or replace malfunctioning parts.

      3. Check for normal functioning of the audio system.

        1. Without code outputs, proceed to A.

        2. With code outputs, proceed to B.



      		B.
      Go to step 5
      A


      4.CHECK FOR DTC

      1. Check for DTCs and note any codes that are output.

      2. Delete the DTC.

      3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

        1. If the DTC does not reoccur, proceed to A.

        2. If the DTC reoccurs, proceed to B.

          HINT:
          Find the output code on the diagnostic trouble code chart.



      		B.
      Go to step 7
      A


      5.PROBLEM SYMPTOMS TABLE

      1. If the fault is not listed on the problem symptoms table, proceed to A.

      2. If the fault is listed on the problem symptoms table, proceed to B.



      		B.
      Go to step 7
      A


      6.OVERALL ANALYSIS AND TROUBLESHOOTING

      1. Terminals of ECU.


      NEXT


      7.REPAIR OR REPLACE

        NEXT


        8.CONFIRMATION TEST

          NEXT

          END