DTC    U0001    High Speed CAN Communication Bus

for Preparation Click here


DESCRIPTION

The engine control unit and the transmission control unit are located inside the ECM. The engine control unit communicates with the transmission control ECU and the Controller Area Network (CAN).
If there is a problem in this intercommunication, the ECM sets a DTC.

DTC No.
DTC Detection Condition
Trouble Area
U0001
  1. Following conditions are met for 2 seconds (1 trip detection logic):
    1. Engine switch on (IG)
    2. Battery voltage is 10 V or more
    3. No intercommunication between engine control ECU and transmission control ECU
ECM

INSPECTION PROCEDURE

1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC U0001)

Result:

Display (DTC output)
Proceed to
U0001
A
U0001 and other DTCs
B



B
GO TO RELEVANT DTC CHART
A

REPLACE ECM