SLIDING ROOF SWITCH ASSEMBLY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT SLIDING ROOF SWITCH ASSEMBLY


    B107152E01

  1. Remove the personal light.

  1. Measure the resistance of the connector.

    Standard resistance:
    Tester Connection
    		Switch Condition
    		Specified Condition
    13 (UP) - 8 (E)
    		TILT UP
    		Below 1 Ω
    13 (UP) - 8 (E)
    		Off
    		10 kΩ or higher
    29 (DOWN) - 8 (B)
    		TILT DOWN
    		Below 1 Ω
    29 (DOWN) - 8 (B)
    		TILT UP
    		10 kΩ or higher
    12 (OPN) - 8 (B)
    		SLIDE OPEN
    		Below 1 Ω
    12 (OPN) - 8 (B)
    		TILT UP
    		10 kΩ or higher
    28 (CLS) - 8 (B)
    		SLIDE CLOSE
    		Below 1 Ω
    28 (CLS) - 8 (B)
    		TILT UP
    		10 kΩ or higher

    If the result is not as specified, replace the personal light assembly.