VEHICLE STABILITY CONTROL SYSTEM > Slip Indicator Light Remains ON

for Preparation Click here


DESCRIPTION

The SLIP indicator blinks during VSC and/or TR(A)C operation.
When the system fails, the SLIP indicator comes on to warn the driver (Click here).
The SLIP indicator comes on when traction control is terminated by pressing the traction OFF switch.

WIRING DIAGRAM


C109397E01


INSPECTION PROCEDURE

NOTICE:
When replacing the ABS and TRACTION actuator assembly, perform zero point calibration (Click here).

HINT:
The SLIP indicator light comes on when the traction OFF switch is ON.

1.INSPECT CAN COMMUNICATION SYSTEM

  1. Check if the CAN communication system DTC is output (Click here).

    Result:

    Condition
    		Proceed To
    DTC is not output
    		A
    DTC is output
    		B



B
REPAIR CAN COMMUNICATION SYSTEM
A


2.INSPECT MULTIPLEX COMMUNICATION SYSTEM

  1. Check if the multiplex communication system DTC is output (Click here).

    Result:

    Condition
    		Proceed To
    DTC is not output
    		A
    DTC is output
    		B



B
REPAIR MULTIPLEX COMMUNICATION SYSTEM
A


3.INSPECT IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED

  1. Check if the skid control ECU connector is securely connected.

    OK:
    The connector should be securely connected.



NG
CONNECT CONNECTOR TO ECU CORRECTLY
OK


4.INSPECT BATTERY

  1. Check the battery voltage.

    Voltage:
    11 to 14 V



NG
INSPECT CHARGING SYSTEM
OK


5.INSPECT TRACTION OFF SWITCH


    C106610E03

  1. Remove the traction OFF switch.

  1. Disconnect the traction OFF switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester Connection
    		Switch Condition
    		Specified Condition
    L43-3 - L43-4
    		Pressed
    		Below 1 Ω
    L43-3 - L43-4
    		Not pressed
    		10 kΩ or higher



NG
REPLACE TRACTION OFF SWITCH
OK


6.INSPECT TRACTION OFF SWITCH (GROUND CIRCUIT)


    C106611E03

  1. Disconnect the traction OFF switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester Connection
    		Specified Condition
    L43-4 - Body ground
    		Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (GND CIRCUIT)
OK


7.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU TO TRACTION OFF SWITCH)


    C110736E02

  1. Disconnect the skid control ECU connector and the traction OFF switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester Connection
    		Specified Condition
    A48-43 (CSW) - L43-3
    		Below 1 Ω
    A48-43 (CSW) - Body ground
    		10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (CSW CIRCUIT)
OK


8.INSPECT COMBINATION METER ASSEMBLY

  1. Check the combination meter assembly (Click here).

    HINT:
    If troubleshooting has been carried out according to the problem symptoms table, refer back to the table and proceed to the next step before replacing the part (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY
OK

REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY