REAR NO. 1 UPPER CONTROL ARM > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. REMOVE DIFFERENTIAL NO.2 SUPPORT PROTECTOR


    G033363

  1. Remove the 2 nuts and the differential No.2 support protector.



3. SEPARATE REAR SHOCK ABSORBER WITH COIL SPRING


    C106393

  1. Remove the bolt and nut, and separate the rear stabilizer link assembly and the load sensing valve sensor bracket from the rear No.2 suspension arm.

  1. Remove the bolt and nut, and separate the rear shock absorber with coil spring from the rear No.2 suspension arm assembly



4. REMOVE REAR NO. 1 UPPER CONTROL ARM


    C104408

  1. Remove the bolts, nuts, washers, and the rear No.1upper control arm from the rear axle carrier.

    NOTICE:
    Push the axle carrier downward.



    C104409

  1. Remove the bolts, nuts, washers, and the rear No.1upper control arm from the rear suspension member.