REAR NO. 2 UPPER CONTROL ARM > INSTALLATION

for Preparation Click here

1. Install the stud of the rear No.2 upper control arm, and temporarily tighten a new nut.
   

2. Install the rear upper control arm, and temporarily tighten the bolt, nut and washer.
   

   HINT:

   Push the axle carrier downward.

3. Fully tighten the nut of the rear No.2 upper control arm.
   

   Torque:

   70 N*m{ 714 kgf*cm , 52 ft.*lbf }

1. Temporarily install the rear shock absorber with coil spring with the bolt and nut.
   

2. Temporarily install the rear stabilizer link assembly and the load sensing valve sensor bracket to the rear No.2 suspension arm assembly with the bolt and nut.
   

1. Jack up the axle carrier, with a wooden block placed between the jack and axle carrier, to apply load to the suspension so that the rear drive shaft assembly becomes level.
   

1. Fully tighten the bolt holding the rear shock absorber with coil spring.
   

   Torque:

   110 N*m{ 1,120 kgf*cm , 81 ft.*lbf }

   NOTICE:

   Turn the bolt while holding the nut.

2. Fully tighten the nut holding the rear stabilizer link assembly.
   

   Torque:

   27 N*m{ 275 kgf*cm , 20 ft.*lbf }

1. Install the differential No.2 support protector with the 2 nuts.