REAR NO. 2 UPPER CONTROL ARM > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. REMOVE DIFFERENTIAL NO.2 SUPPORT PROTECTOR


    G033363

  1. Remove the 2 nuts and the differential No.2 support protector.



3. SEPARATE REAR SHOCK ABSORBER WITH COIL SPRING


    C106393

  1. Remove the bolt and nut, and separate the rear stabilizer link assembly and the load sensing valve sensor bracket from the rear No.2 suspension arm.

  1. Remove the bolt and nut, and separate the rear shock absorber with coil spring from the rear No.2 suspension arm assembly



4. REMOVE REAR NO. 2 UPPER CONTROL ARM


    C104530E01

  1. Remove the nut on the axle carrier side.

    SST
    09628-00011  

  1. Using SST, separate the rear No.2 upper control arm.

    NOTICE:
    1. Securely tie the string of the SST to the vehicle.
    2. Do not damage the dust cover.
    3. Securely set the SST on the spacer of the axle carrier.
    4. If the spacer of the axle carrier comes off, replace the axle carrier with a new one.



    G032799

  1. Remove the bolt, nut, washer, and rear No.2 upper control arm.

    HINT:
    Push the axle carrier downward.