THEFT DETERRENT SYSTEM > ON-VEHICLE INSPECTION


HINT:
Before checking the theft deterrent system function, cancel the entry and start system.



1. OUTLINE OF THEFT DETERRENT SYSTEM

  1. When the theft deterrent system detects that the vehicle is being tampered with, the horns sound and lights flash continuously. For Europe, Russia, Turkey and China models, theft warning siren sounds simultaneously.

  1. The system has 2 modes: active arming mode (see step 2) and passive arming mode (see step 3). Passive arming mode can be turned on and off using the intelligent tester.

  1. Each mode has 4 states: disarmed state, arming preparation state, armed state and alarm sounding state.

    1. Disarmed state:

      1. The alarm function is not operating.
      2. The theft deterrent system is not operating.

    2. Arming preparation state:

      1. The theft deterrent system is not operating.

    3. Armed state:

      1. The theft deterrent system is operating.

    4. Alarm sounding state:

      1. The alarm function is operating (30 +- 5 seconds).

      Refer to table below for alarm method and time: 
      Alarm Method
      		Hazard Warning Light
      		Blinking (cycle of flasher relay)
      Vehicle Horn
      		Sounding (cycle of 0.4 seconds)
      Security Horn*1
      		Sounding (cycle of 0.4 seconds)
      Headlight*1
      		Flashing
      Taillight*1
      		Flashing
      Room Light
      		Illuminating
      Theft Warning Siren*2
      		Sounding (cycle of 0.4 seconds)
      Security Indicator
      		Illuminating
      Alarm Time
      		30 +- 5 seconds

      HINT:
      If, during the alarm sounding state, one of the doors is unlocked without using the proper key, a forced door lock signal will be output (see step 4).
      *1: Countries other than Europe, Russia, Turkey and China
      *2: Europe, Russia, Turkey and China



2. ACTICE ARMING MODE

HINT:
  1. Active arming mode starts the alarm control immediately after the doors are locked.
  2. Before checking the theft deterrent system, cancel the entry and start system.


System state
State switching condition
Transfer to
1. Disarmed state
  1. With all doors and engine hood closed, lock all doors by wireless operation.
  2. With all doors and engine hood closed, lock all doors using mechanical key.*1
  3. With a door or engine hood open, close all doors and engine hood, and lock all doors.*1
2. Arming preparation state
2. Arming preparation state
  1. Unlock all doors by wireless operation.
  2. Unlock all doors using mechanical key.*1
  3. Open engine hood.
  4. Depress brake pedal, put and hold key 10 mm (0.4 in.) over engine switch with key ornament facing engine switch for 5 seconds, and turn engine switch on (ACC or IG).
  5. Reconnect battery.
1. Disarmed state
  1. Allow 30 (+- 1.5) seconds to elapse.
3. Armed state
3. Armed State
  1. Unlock all doors by wireless operation.
  2. Unlock all doors using mechanical key.*1
  3. Depress brake pedal, put and hold key 10 mm (0.4 in.) over engine switch with key ornament facing engine switch for 5 seconds, and then start engine and allow 2 seconds to elapse.
1. Disarmed state
  1. Open engine hood.
  2. Open a door.
  3. Unlock a door without using wireless operation.*2
  4. Unlock a door without using wireless operation or mechanical key.*1
  5. Disconnect and reconnect cable from negative (-) battery terminal.*3
  6. Force ignition system to turn on without using proper engine start method.
4. Alarm sounding state
4. Alarm sounding state
  1. Unlock all doors using wireless operation.*2
  2. Unlock all doors using wireless operation or mechanical key.*1
  3. Depress brake pedal, put and hold key 10 mm (0.4 in.) over engine switch with key ornament facing engine switch for 5 seconds, and then start engine and allow 2 seconds to elapse.
1. Disarmed state
  1. Allow 30 (+- 5) seconds to elapse.
3. Armed state (alarm stops sounding)

HINT:
*1: Countries other than Europe, Russia, Turkey and China
*2: Europe, Russia, Turkey and China
*3: For Europe, Russia, Turkey and China models, theft warning siren begins to sound as soon as the battery cable is reconnected.



3. PASSIVE ARMING MODE (EXCEPT EUROPE, RUSSIA, TURKEY AND CHINA)

HINT:
  1. Before checking the theft deterrent system function, cancel the entry and start system.
  2. Disarmed state (1) is the normal disarmed state.
  3. Disarmed state (2) is set from either the disarmed state (1) or the arming preparation.
  4. Passive arming mode can be turned on and off using the intelligent tester.
  5. The vehicle's initial alarm setting is active arming mode.
  6. During passive arming mode, the theft deterrent system enters the armed state even if the doors are not locked.
  7. Passive arming mode starts the alarm control after the doors are closed.
  8. Detecting that the doors are unlocked does not set off the alarm during passive arming mode.
  9. A forced door lock signal is not output during passive arming mode (see step 4).
  10. When the theft deterrent system detects that the doors are opened during passive arming mode, the alarm is not set off immediately depending on the entry delay time setting.
  11. If any of the following conditions is fulfilled during passive arming mode, the theft deterrent system will be changed to active arming mode.
    1. With all doors and engine hood closed, lock all doors by wireless operation.
    2. With a door or engine hood open, close all doors and engine hood, and then lock all doors.
    3. With all doors and engine hood closed, lock all doors using mechanical key. (Except Europe, Russia, Turkey and China)


System state
State switching condition
Transfer to
1. Disarmed state (1)
  1. With engine switch off, open a door or engine hood.
2. Disarmed state (2)
2. Disarmed state (2)
  1. Close all doors and engine hood.
3. Arming preparation state
  1. Press UNLOCK button on wireless transmitter.
  2. Insert mechanical key into driver side door key cylinder and turn key to unlock position.
  3. Depress brake pedal, put and hold key 10 mm (0.4 in.) over engine switch with key ornament facing engine switch for 5 seconds, and turn engine switch on (ACC or IG).
  4. Disconnect and reconnect cable from negative (-) battery terminal.
1. Disarmed state (1)
3. Arming preparation state
  1. Allow 30 (+- 1.5) seconds to elapse.
4. Armed state
  1. Open a door or engine hood.
2. Disarmed state (2)
4. Armed state
  1. Press UNLOCK button on wireless transmitter.
  2. Insert mechanical key into driver side door key cylinder and turn key to unlock position.
  3. Depress brake pedal, put and hold key 10 mm (0.4 in.) over engine switch with key ornament facing engine switch for 5 seconds, and turn engine switch on (IG).
  4. With engine speed 550 rpm, allow 2 seconds to elapse.
1. Disarmed state (1)
  1. Open luggage compartment door using wireless operation or mechanical key.
1. Disarmed state (2)
  1. Open a door (except for luggage compartment door) and allow entry delay time* to elapse.
  2. Open engine hood.
  3. Disconnect and reconnect cable from negative (-) battery terminal.
  4. Open luggage compartment door without using wireless operation or mechanical key.
  5. Force engine ignition system to turn on without using proper engine start method.
5. Alarm sounding state
5. Alarm sounding state
  1. Press UNLOCK button on wireless transmitter.
  2. Insert mechanical key into driver side door key cylinder and turn key to unlock position.
  3. Depress brake pedal, put and hold key 10 mm (0.4 in.) over engine switch with key ornament facing engine switch for 5 seconds, and turn engine switch on (IG).
  4. With engine speed 550 rpm, allow 2 seconds to elapse.
1. Disarmed state (1)
  1. Open luggage compartment door using wireless operation or mechanical key.
2. Disarmed state (2)
  1. Allow 30 (+- 5) seconds to elapse.
4. Armed state (alarm stops)

HINT:
*: When a door is opened while all doors are closed during passive arming mode, the entry delay time starts. If the state switching condition (from armed state to disarmed state (1) or (2)) is fulfilled, during the entry delay time, the theft deterrent system will return to disarmed state (1) or (2). However, if the state transfer condition is not fulfilled, the theft deterrent system will assume that a break-in or theft is occurring and sound the alarm.
The entry delay time can be selected among the following ; 0, 14 or 30 seconds.



4. FORCED DOOR LOCK CONTROL

  1. The forced door lock control also helps to prevent the vehicle from being tampered with. When a door is unlocked and the alarm starts, the door is forced to lock by a forced door lock signal.

    1. Conditions that force the doors to lock:

      1. 0.4 seconds have elapsed after the previous output of a forced door lock signal.
      2. The theft deterrent system is in the alarm sounding state of active arming mode.
      3. A door is unlocked.



5. PANIC ALARM CONTROL (OPTIONAL FUNCTION)

  1. The panic alarm control activates the panic alarm when the wireless transmitter PANIC switch is pressed. The panic alarm control operates independently from the theft deterrent system alarm control's change from the armed state to the alarm sounding state.

    1. Conditions that cause the panic alarm control to set off the panic alarm:
      The panic alarm control sets off the panic alarm when the PANIC switch on the wireless transmitter is pressed for over 2.4 seconds under the following conditions.

      1. The engine switch is off.
      2. The theft deterrent system is not in the alarm sounding state.
      3. The panic alarm control is not operating (the alarm is not set off).

    2. Conditions that cause the panic alarm control to shut off the alarm:
      The panic alarm control shuts off the panic alarm when any of the following conditions is fulfilled during panic alarm operation.

      1. The engine switch is turned on.
      2. The wireless transmitter lock / unlock switch is pressed.
      3. 60 + - 5 seconds have pressed and the panic alarm has ended.
      4. The theft deterrent system switches to the alarm sounding state. However, the alarm is still sounding, because the theft deterrent system has switched to the alarm sounding state.
        Conditions for canceling the panic alarm are the same as for the alarm control.

      HINT:
      For more information about the active mode, see step 2.



6. ALARM MEMORY FUNCTION

  1. If the alarm is set off (tampering is detected) while the theft deterrent system is in the armed state, the alarm memory function will record it. Whenever the theft deterrent system is canceled, the alarm memory function causes the taillights to illuminate for 2 seconds in order to inform you that the alarm has been set off.

    1. Conditions of the alarm memory function that cause the taillights to illuminate:
      When the theft deterrent system has entered the alarm sounding state (tampering has been detected) even once, the taillights will illuminate for 2 seconds if either of the following conditions is fulfilled.

      1. This system changed to the disarmed state from the armed state during active arming mode.
      2. This system changed to the disarmed state (1) from the armed state during passive arming mode.

      HINT:
      For more information about active arming mode, see step 2. For more information about passive arming mode, see step 3.



7. SECURITY INDICATOR OUTPUT

  1. The security indicator turns on and off based on output signals from the multiplex network body ECU. However, in some cases, the actual status of the security indicator is different from the output signals of the multiplex network body ECU.

    Output: 
    State of Theft Deterrent System
    		Security Indicator
    Output Signals from Body ECU
    		Actual Lighting Condition
    Disarmed state
    		OFF
    		OFF (Immobiliser system not set)
    BLINKING (Immobiliser system set)
    Arming preparation state
    		ON
    		ON
    Armed state
    		OFF
    		BLINKING
    Alarm sounding state
    		ON
    		ON
    Blinking cycle: 
    Time
    		Security Indicator
    0.2 seconds
    		ON
    1.8 seconds
    		OFF

    HINT:
    When the immobiliser system is set, the security indicator blinks during the disarmed state and the armed state due to the output signals from the immobiliser system.