HIGH INTENSITY DISCHARGE HEADLIGHT BULB > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. INSTALL HIGH-INTENSITY DISCHARGE HEADLIGHT BULB


B110739

  1. Hook the set spring lock to the groove to install it.



    B109731

  1. Turn the bulb in the direction indicated by the arrow and install the socket.



2. INSTALL HEADLIGHT NO. 1 BACK COVER


B109732

  1. Turn the back cover in the direction indicated by the arrow and install it.



3. INSTALL ENGINE ROOM SIDE COVER


A105934E01

  1. Install the side cover with the 3 clips.



4. INSTALL COOL AIR INTAKE DUCT SEAL


B106147

  1. Install the duct seal with the 7 clips.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


6. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.