HIGH INTENSITY DISCHARGE HEADLIGHT BULB > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE COOL AIR INTAKE DUCT SEAL


B106147

  1. Using a clip remover, remove the 7 clips and duct seal.



3. REMOVE ENGINE ROOM SIDE COVER


A105934E01

  1. Remove the 3 clips and side cover.



4. REMOVE NO. 1 HEADLIGHT BACK COVER


B109733

  1. Turn the back cover in the direction indicated by the arrow and remove it.



5. REMOVE HIGH-INTENSITY DISCHARGE HEADLIGHT BULB


    B109734

  1. Turn the bulb in the direction indicated by the arrow and remove the bulb socket.



    B109730E01

  1. Release the set spring lock as shown in the illustration and remove the bulb.