SIDE TURN SIGNAL LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY


E110334E01

  1. Detach the 2 claws in the order indicated by the arrows in the illustration, and detach the side turn signal light from the vehicle body.

  1. Disconnect the connector and remove the side turn signal light.