FUEL INJECTOR > INSPECTION |
| 1. INSPECT INJECTOR RESISTANCE |
![]() |
Measure the resistance between the injector terminals.
| 2. INSPECT INJECTION VOLUME AND FOR LEAKAGE |
![]() |
Install the fuel tube connector to SST (hose), then connect the tube connector to the fuel pipe (vehicle side).
![]() |
Install the O-ring to the fuel injector.
Connect SST (adapter and hose) to the injector, and hold the injector and union with SST (clamp).
Put the injector into the graduated cylinder.
![]() |
Operate the fuel pump.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Push the intelligent tester main switch ON.
Select the following menus: Powertrain / Engine / Active Test / Control the Fuel Pump /Speed.
![]() |
Connect SST (wire) to the injector and the battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.
![]() |
Check for leakage.
When operating the fuel pump, disconnect the SST (wire) tester probes from the battery and check the fuel leakage from the injector.