CRUISE CONTROL ECU (for RHD) > INSTALLATION

for Preparation Click here



1. INSTALL DISTANCE CONTROL ECU ASSEMBLY



B112082E02

  1. Install the distance control ECU with the 2 nuts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

    NOTICE:
    Do not install the distance control ECU assembly if it has been damaged or if it has received some sort of shock.

  1. Connect the distance control ECU connector.



2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


B108095E01

  1. Connect the connectors.

  1. Attach the 2 claws to install the under cover.

  1. Install the 2 screws.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. INITIALIZE DISTANCE CONTROL ECU

NOTICE:
When replacing the distance control ECU, perform the following procedures so that the ECU can recognize the specification.

  1. Be sure to perform the following procedures after replacing the distance control ECU.

    1. Turn the engine switch on (IG).

    2. Push the cruise main switch ON..

    3. With the brake pedal depressed, push the cruise control main switch to RES/ACC 3 times within 3 seconds. Check that the VSC buzzer sounds at this time.

      NOTICE:
      1. Do not turn the headlight dimmer switch on at this time because optical axis automatic adjustment mode has already started, which could lead to an incorrect optical axis setting
      2. If the headlight dimmer switch is turned on by mistake, readjust the optical axis.



5. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.