BRAKE MASTER CYLINDER (w/ VSC) > REMOVAL

for Preparation Click here



1. PRECAUTION
(Click here)


2. REMOVE COOL AIR INTAKE DUCT SEAL


A105932E01

  1. Remove the 7 clips and duct seal.



3. REMOVE ENGINE ROOM SIDE COVER LH


    A110867E01

  1. Remove the 3 clips and side cover.



4. REMOVE ENGINE ROOM SIDE COVER RH


    A110866E01

  1. Remove the nut, 2 clips and side cover.



5. REMOVE FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY LH


B108983E01

  1. Using a clip remover, detach the 3 clips and remove the side seal.



6. REMOVE FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



7. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH

  1. Remove the nut, wiper arm and blade.



8. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH

  1. Remove the nut, wiper arm and blade.



9. REMOVE FRONT FENDER TO COWL SIDE SEAL LH


B107358E01

  1. Pull the cowl side seal in the direction indicated by the arrow in the illustration to detach the 2 claws and remove the cowl side seal.



10. REMOVE FRONT FENDER TO COWL SIDE SEAL RH

HINT:
Use the same procedures described for the LH side.



11. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY


    B111074E01

  1. Remove the 2 clips and detach the 5 claws.



    B111075E01

  1. Pull the ventilator louver in the direction indicated by the arrow in the illustration to detach the 10 claws and remove the ventilator louver.



12. DRAIN BRAKE FLUID

NOTICE:
If brake fluid leaks onto any painted surface, clean it off completely.



13. REMOVE FRONT WHEEL


14. REMOVE ENGINE ROOM RELAY NO.3 BLOCK


    C113039E01

  1. Remove the bolt, nut and relay No.3 block.

    NOTICE:
    Cover the relay No.3 block with a shop rag or piece of cloth to prevent brake fluid from adhering to it.



15. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

  1. Disengage the clamp and disconnect the warning switch connector.



    C113041E01

  1. Using SST, disconnect the 2 brake tubes from the brake master cylinder sub-assembly.

    SST
    09023-00101  



    C113040E02

  1. Remove the 2 nuts and brake master cylinder sub-assembly from the brake booster assembly.

  1. Remove the O-ring from the brake master cylinder sub-assembly.