BRAKE MASTER CYLINDER (w/ ECB) > REASSEMBLY

for Preparation Click here

1. Install the brake stroke simulator cylinder to the brake simulator bracket with the 2 bolts.
   

   Torque:

   8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

2. Install the connector to the brake stroke simulator bracket.
   

1. Temporarily install the brake master cylinder push rod clevis and the lock nut.
   

1. Apply lithium soap base glycol grease to 2 new master cylinder reservoir grommets and install them to the master cylinder assembly.
   

2. Install the brake master cylinder reservoir with the screw.
   

1. Temporarily install a new master cylinder gasket to the master cylinder assembly. Connect the brake stroke simulator cylinder tube to the brake stroke simulator cylinder sub-assembly and master cylinder assembly and loosely tighten the tube.
   

2. Install a new master cylinder gasket, master cylinder assembly and brake stroke simulator bracket to the master cylinder bracket with the 2 bolts.
   

   Torque:

   12.5 N*m{ 128 kgf*cm , 9 ft.*lbf }

3. Use the SST to fully tighten the brake stroke simulator cylinder tube.
   

   SST

   09023-00101  
   

   Torque:

   15 N*m{ 155 kgf*cm , 11 ft.*lbf }