FRONT BRAKE > DISASSEMBLY

for Preparation Click here



1. REMOVE CYLINDER BOOT


    C105653

  1. Using a screwdriver, remove the cylinder boot from the disc brake cylinder assembly.



2. REMOVE FRONT BRAKE PISTON


    F046698E02

  1. Prepare a wooden plate to hold the pistons.

  1. Place the plate between the pistons and insert a pad into one side.



    C105651

  1. Use compressed air to remove the pistons alternately from the disc brake cylinder assembly.

    CAUTION:
    Do not place your fingers in front of the pistons when using compressed air.



3. REMOVE FRONT BRAKE PISTON

  1. Using a screwdriver, remove the 4 piston seals from the disc brake cylinder assembly.



4. REMOVE FRONT DISC BRAKE BLEEDER PLUG


    C105652

  1. Remove the front disc brake bleeder plug from the disc brake cylinder assembly.



5. REMOVE FRONT DISC


    F041543E03

  1. Put matchmarks on the front disc and the axle hub.

  1. Remove the front disc.