REAR BRAKE > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for LH the side.



1. REMOVE REAR WHEEL


2. DRAIN BRAKE FLUID

NOTICE:
Wash brake fluid off immediately if it is spilled on any painted surface.



3. REMOVE REAR DISC BRAKE PAD KIT


    C109125E04

  1. Remove the pin hold clip and disengage the engaged parts of anti-squeal spring.

  1. Remove the 2 pad guide pins and anti-squeal spring.

  1. Remove the 2 brake pads with the anti-squeal shims.



4. REMOVE ANTI-SQUEAL SHIM KIT REAR

  1. Remove the 2 anti-squeal shims from each pad.



5. DISCONNECT REAR LH FLEXIBLE HOSE


    C109279

  1. Remove the union bolt and gasket from the disc brake cylinder assembly rear, then disconnect the flexible hose.



6. REMOVE REAR DISC BRAKE REAR CYLINDER SLIDE PIN


    C109278

  1. Remove the rear disc brake rear cylinder slide pin and tilt the disc brake cylinder assembly toward the rear of the vehicle.



7. REMOVE DISC BRAKE CYLINDER ASSEMBLY LH

  1. Remove the 2 bolts and cylinder assembly rear together with the caliper support bracket.

  1. Remove the 2 caliper plates No.1 from the caliper support bracket.