SKID CONTROL ECU > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
(Click here)


2. REMOVE COOL AIR INTAKE DUCT SEAL


A105932E01

  1. Remove the 7 clips and duct seal.



3. REMOVE ENGINE ROOM SIDE COVER LH (for LHD)


B107979E01

  1. Using a clip remover, remove the 3 clips and side cover.



4. REMOVE ENGINE ROOM SIDE COVER RH (for RHD)


B107980E01

  1. Remove the cap nut.

  1. Using a clip remover, remove the 3 clips and side cover.



5. REMOVE SKID CONTROL ECU ASSEMBLY

  1. Disconnect the connector.



    C113034E01

  1. Remove the 3 bolts and skid control ECU assembly.



    C100671

  1. Pull the 2 lock levers upward to release the lock and disconnect the 3 connectors.