ABS MOTER RELAY (w/ VSC) > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT ABS MOTOR1 RELAY


    F050241E01

  1. Remove the ABS MOTOR1 relay.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    3 - 5
    		Always
    		10 kΩ or higher
    (No continuity)
    3 - 5
    		Apply B+ between terminal 1 and 2
    		Below 1 Ω
    (Continuity)



2. INSPECT ABS MOTOR2 RELAY


    F050240E01

  1. Remove the ABS MOTOR2 relay.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    3 - 5
    		Always
    		10 kΩ or higher
    (No continuity)
    3 - 5
    		Apply B+ between terminal 1 and 2
    		Below 1 Ω
    (Continuity)