3UZ-FE COOLING > SERVICE DATA |
| No. 1 cooling fan motor | Standard current 2 to 11 A (when the A/C switch is on (MAX COOL and the magnet clutch is operating)) |
| Standard current 5.6 to 11.6 A at 20°C (68°F) (when the battery is connected to the fan motor connector) | |
| Standard current 2 to 11 A (when the water temperature sensor connector is disconnected) | |
| No. 2 cooling fan motor | Standard current 2 to 11 A (when the A/C switch is on (MAX COOL and the magnet clutch is operating)) |
| Standard current 5.6 to 11.6 A at 20°C (68°F) (when the battery is connected to the fan motor connector) | |
| Standard current 2 to 11 A (when the water temperature sensor connector is disconnected) | |
| Water inlet with thermostat | Valve opening temperature 80 to 84°C (176 to 183°F) |
| Valve lift 8.0 mm (0.315 in.) or more at 95°C (203°F) | |
| Cooling fan relay | Standard resistance: 10 MΩ or higher Standard resistance: Below 1 Ω (when battery voltage is applied to terminals 1 and 2) |
| Cooling fan ECU | Standard voltage 9 to 14 V (when turn the engine switch on (IG)) |
